Kenwood TS-450S Instruction Manual page 65

4-13-4. Programmable Band Scan
Pressing the SCAN key during VFO A or VFO B operation initiates scan.
"If nothing is stored in channels 90 to 99, the next frequency is stored in channel 90 automatically when the
SCAN key is pressed.
Lower tuning frequency limit: | 30.00kHz
Upper tuning frequency limit:
Upper tuning frequency limit:
Upper tuning frequency limit:
It is possible to scan the whole receiver range.
40.000MHz (TS-450S except E type)
29.99999MHz (TS-450S Etype only)
60.000MHz (TS-6908 only)
| |f upper and lower limits are programmed in channels 90 to 99, performed according to the settings.
The channel to be scanned can be specified.
Channel Selection
1.
4.
While holding the SCAN key depressed press the
numeric key that corresponds with the program scan
range you want to scan.
For example press the 3 key if you want to scan
between the limits specified in memory channel 93.
Press 4 if you want to scan between the limits
specified in memory channel 94, and so on.
. Scan will proceed from the lowest frequency towards
the highest frequency specified in memory channel.
. The mode of operation and filter bandwidth can be
changed during scan.
To cancel scan press the CLH key.
You can specify up to 10 different groups to scan. Simply hold the scan key depressed and press the
numeric key corresponding to the different groups you wish to scan.
For example:
When 14.000 MHz (lower limit) and 14.010 MHz (upper
limit) are stored in channel 91, and 21.000 MHz (lower
limit) and 21.010 MHz (upper limit) are stored in channel
92:
Press Numeric keys 1 and then 2 while holding down
the SCAN key. Scanning will be repeated within the
ranges stored in channels 91 and 92.
Memory channel 91 Memory channel 92
14.000 14.010MHz 21.000 21.010MHz
65