Ordering Spare Parts; Adjustments - Kenwood TS-850S Instruction Manual

Hide thumbs Also See for TS-850S:
Table of Contents

Advertisement

Note
TRANSMIT
Symptom
Probable cause
Corrective action
Output
1. Microphone
plug is not plugged
in.
2. Low microphone gain.
3. Poor antenna connection.
1. Plug MIC in.
2. Increase the MIC gain control.
3. Connect antenna securely.
VOX does not operate.
1. GAIN control too low.
2. ANTI control too high.
1. See section 4-1-2, GAIN control.
2. See section 4-1-2, ANTI control.
VOX trips by speaker output.
ANTI control too low.
See section 4-1-2, ANTI control.
Linear amplifier does not key.
1. LINEAR
AMP
switch
on
rear
panel was not turned ON.
2. REMOTE connector is miswired,
or has a poor contact.
1. Move the switch as described in
section 6-6-5.
2. Correct wiring.
Amplitude
modulation
does
not
work.
PROC switch is ON.
PROC switch is OFF.
6-5.
ORDERING SPARE PARTS
6-6.
ADJUSTMENTS
6-6-1.
Removing the covers
Remove the top cover, and the bottom covers from the transceiver.
Cautions
cable.
2. Do not pull wiring when opening or pinch wires when closing cases.
Cover Removal
64

Advertisement

Table of Contents
loading

Table of Contents