Kenwood TS-450S Instruction Manual page 17

= AT TUNE
Qj — F =
5
26
These keys are used to select the desired mode of
operation. When a MODE key is pressed the first
character of that mode will be sounded in Morse code
thru the internal speaker.
24 LSB/USB key
Press the LSB/USB key to alternate between
LSB and USB mode.
95 CW/FSK key
Press the CW/FSK key to alternate between CW
and FSK mode.
26 FM/AM key
Press the FM/AM key to alternate between FM
and AM mode.
27) F.LOCK key
The selected dial frequency and mode are
locked.
' Note |
| When the F.LOCK key is on, the TF-SET, |
| FILTERKeys, METER, VOICE keys, NOTCH, |
АОС, NB, PROC., AIP, RIT, ХІТ and RIT/XIT |
| control are still active. |
28 ΝΟΙΟΕ кеу
Press this key to activate the optional voice
synthesizer unit VS-2.
29) TUNING knob (VFO)
Rotate the knob to select the desired frequency.
The dial drag is adjustable by holding the
outside knob and turning the inside knob
clockwise to increase drag, and
counterclockwise to decrease drag.
38)
@FUNCTION keys
30)
38
TF-SET key
Depressing this key will allow you to rapidly set
or check the transmit frequency, during SPLIT
and ВІТ / ХІТ operations, without the need of
actually transmitting.
) A/B key
This key switches between VFO A or VFO Β.
M/V key
This key switches between the VFO or memory.
SPLIT key
Press this key for split operation.
RIT key
Press to turn the RIT ON or OFF.
A=B key
Equalizes the frequencies, modes and filter
selections of VFO A and VFO B.
XIT key
Press to turn the XIT ON or OFF.
1MHz key
This key causes the UP/DOWN switches to
change the operating frequency in 1 MHz steps
or only select amateur bands. When the 1 MHz
step position is selected, the 1MHz indicator will
light.
When the 1MHz key has been pressed, the
frequency is changed in 1MHz steps regardless
of the amateur band.
The frequency step can be changed to 500 kHz.
(See 4-11-15. Function setting when the power
is switched on.)
UP/DOWN switch
Pressing the UP switch increases the frequency,
and pressing the DOWN switch decreases it.