Kenwood TS-450S Instruction Manual page 2

Thank you for purchasing this new transceiver.
IMPORTANT
Please read this Instruction Manual
carefully before placing the transceiver
in service.
SAVE THIS INSTRUCTION
MANUAL.
The following explicit definitions apply in
this manual:
Note : If disregarded, inconvenience
only, no risk of equipment
damage or personal injury.
Caution : Equipment damage may
occur, but not personal injury.
This instruction manual covers the
following models.
HF TRANSCEIVER
©) TS-4508
WITH AUTOMATIC ANTENNA TUNER
© Τ5-4508
WITHOUT AUTOMATIC ANTENNA
TUNER
ALL MODE MULTI BANDER
С) TS-690S
WITHOUT AUTOMATIC ANTENNA
TUNER
IMPORTANT
The 6m (50MHz) BAND IS NOT
AVAILABLE IN SOME AREAS.
Notice to the user:
One or more of the following statements
may be applicable to this equipment.
FCC WARNING
This equipment generates or uses radio
frequency energy. Changes or
modifications to this equipment may
cause harmful interference unless the
' modifications are expressly approved in
the instruction manual. The user could
lose the authority to operate this
equipment if an unauthorized change or
modification is made.
This equipment has been tested and
found to comply with the limits for a
Class B digital device, pursuant to Part
115 of the FCC Rules. These limits are
designed to provide reasonable
protection against harmful interference in
а residential installation. This equipment
generates, uses and can generate radio
frequency energy and, if not installed and
| used in accordance with the instructions,
may cause harmful interference to radio
| communications. However, there is no
| guarantee that the interference will not
occur in a particular installation. If this
equipment does cause harmful
interference to radio or television
reception, which can be determined by
| turning the equipment off and on, the
user is encouraged to try to correct the
interference by one or more of the
following measures:
-- Reorient or relocate the receiving
antenna.
-- Increase the separation between
| the equipment and receiver.
|-- Connect the equipment into ап
outlet on a circuit different from that
to which the receiver is connected.
-- Consult the dealer for technical
assistance. |