Kenwood TS-450S Instruction Manual page 74

4-20. DATA TRANSFER FUNCTION
Connect the two transceivers, and transfer data from one to the other. |
| Notes
| 1. Other functions may be slowed down while the data is being transferred.
| 2. Data can be transferred between the TS- 4508, TS- 6905, апа TS-850S. |
4-20-1. Connection
Make up a connection cable with 6-pin DIN plugs, or use a 6-pin DIN cord (1m) to connect the ACC1
connectors of the two transceivers. For 6-pin DIN plugs (option, part Νο. Е07-0654-05) or 6-pin DIN cord
(option, part No. E30-3047 -05), contact your nearest KENWOOD authorized service center or dealer.
6-Pin cable (E30-3047-05}
= p
Pin No. | I Si IN e Е .. i ignal Nam |
| 1 GND | Signal ground '
| 2 TXD | Transmit data
i 3 | RXD : Receive data Four-wire shielded cable
| 4 | CTS ` Transmit enable | | | σσ
| 5 | RTS | Receive enable ES
| 6 | NC | No connection з < (plug viewed
| | = | zt » ` (plug viewed from the front)
from the front)
Note
The IF-232C control cable cannot be used for this function. |
If а DSP-100 is connected to one of the transceivers, connect as shown in Figure 1.
оо
Slave
6-Pin cable (E30-3047-05)
DSP-100
p EER
τρ =
ЫЕ
88
| Figure shows TS-450S
Fig. 1
74