Door - Vulcan-Hart VPX3 Service Manual

VPX SERIES STEAMERS - REMOVAL AND REPLACEMENT OF PARTS
5. Remove mounting nuts & washers from the rear
cooking compartment support legs and remove
base.
6. Remove outer nut on drain valve stem and lift
off drain handle assembly.
7. Remove manual drain valve from cooking
compartment drain pipe.
8. Clean thread sealant residue from drain pipe
threads and apply new sealant.
9. Install a replacement drain valve.
A. Tighten valve body so that actuator stem is
pointing towards front of steamer.
10. Reverse procedure to re-assemble from step 6
and check steamer for proper operation.
WARNING: DISCONNECT THE ELECTRICAL
POWER TO THE MACHINE AT THE MAIN
CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT
BOX INDICATING THE CIRCUIT IS BEING
SERVICED.
Removal
1. Remove top cover as outlined under "COVERS
AND PANELS".
2. Open the door.
3. Pull hinge rod up.
4. Reverse procedure to install, making sure the
door bushings are in place.
Page 9 of 20

DOOR

F25111 (March 2002)