Table of Contents
Advertisement
Playback your Recordings
Playback using the LCD Monitor
* Insert a recorded cassette.
* SetPowerto VCR.
1 Press LCO-OPEN to unlock the LCD
monitor and swing open.
Press REWIND/SEARCH
to rewind
the tape.
3 Press PLAY to start playback.
To adjust the volume:
Hold down VOLUME KEY until the volume
setting screen appears (page 27). Then
rotate VOLUME KEY to adjust the volume
of the built-in speaker. To disappear the
volume setting screen, hold down VOLUME
KEY again.
* Adjust the picture on the LCD monitor if
needed (page 31).
UJ
£o
2
O
O
"9
(D
=
i"
z
O
=
Built-in
4
Speaker
Press STOP to stop playback.
* When the tape reaches its beginning
during rewind or rewind search, it will
stop automatically.
* |f you press PLAY for more than 5
seconds, the Palmcorder will
start the Repeat Playback mode
when the tape reaches its end. The
letter "R C^" will appear in the EVF
and LCD monitor.
To exit the Repeat
Playback mode,
turn the
You can place the Palmcorder on a table,
Palmcorder OFF.
etc. for viewing. Rotate the LCD Monitor
180° and swing it up against the
| Note |
Palmcorder body as shown.
* When a tape recorded in LP mode on
another digital video camera is played
back on this unit, the picture may appear
mosaic.
* Using the LCD monitor reduces battery
operating time.
* Connect earphones (not supplied) to the
PHONES Jack.
35
Advertisement
Table of Contents
