Table of Contents
Advertisement
Playback using the LCD Monitor
You can also use the LCD monitor to
playback your recording.
LCD-OPEN
Button
REWIND
SEARCH
STOP
Button
Button
180°
90°
You can place the Palmcorder on a table,
etc. for viewing. Rotate the LCD Monitor
180° and swing it up against the
Palmcorder body as shown.
100-K.28-33.p65
Playback your Recordings
VOLUME KEY
PLAY
Button
Built-in
Speaker
PHONE
Jack
33
Before you begin...
• Connect the Palmcorder to a power source
(pages 10, 11).
• Insert a recorded cassette.
• Set Power to VCR.
1
Press LCD-OPEN to unlock the LCD
monitor and swing open.
2
Press REWIND/SEARCH to rewind
the tape.
3
Press PLAY to start playback.
To adjust the volume:
Hold down VOLUME KEY until the volume
setting screen appears (page 25). Then
rotate VOLUME KEY to adjust the volume
of the built-in speaker. Hold down the
VOLUME KEY again to make the volume
setting screen disappear.
• Adjust the picture on the LCD monitor if
needed (page 29).
4
Press STOP to stop playback.
• When the tape reaches its beginning
during rewind or rewind search, it will
stop automatically.
• If you press PLAY for more than
5 seconds, the Palmcorder will start
the Repeat Playback mode when the
tape reaches its end. The letter "R
will appear in the EVF
and LCD monitor.
To exit the Repeat
Playback mode,
turn the
Palmcorder OFF.
Note
• When a tape recorded in LP mode on
another digital video camera is played
back on this unit, the picture may appear
mosaic.
• Using the LCD monitor reduces battery
operating time.
• Connect earphones (not supplied) to the
PHONE Jack.
00/06/14, 11:55
"
R
33
Advertisement
Table of Contents
