Copying From Digital Equipment (Dubbing) - Panasonic Digital Palmcorder PalmSight PV-DV800 Operating Instructions Manual

Special Features
Copying from Digital cabal did aule | e
Equipment (dubbing)
ERN oth
Palmcorders to their power
High quality digital-to-digita! copying can * Connect the two Palmcorders using the DV
be accomplished if both Palmcorders interface cable (4-pin to 4-pin).
incorporate the digital in/out IEEE 1394 * Turn both Palmcorders ON.
interface (DV interface cable is not
supplied).
1 Insert a pre-recorded tape into the
Source source (playing) Palmcorder, and set
(Playing) POWER to VCR.
Palmcorder DEAE OE EAE
2 Insert a blank tape with the record
DV Input/ tab in place into the target (recording)
Output Palmcorder and set POWER to VCR.
3 Press PLAY on the source
Recording Palmcorder. When the tape reaches
Palmcorder the point you want to start dubbing,
press PAUSE.
4 Hold down REC and press PLAY the
target (recording) Palmcorder or
remote control (optional, page 74).
Press PAUSE to pause the tape at the
starting point of the dub.
5 Simultaneously, press PAUSE
Buttons on both units to begin the
dubbing.
DV Interface Cable
(optional)
STOP PLAY PAUSE REC
Button Button Button Button
i
y
©
9.
=
"Tl
©
D
=
c
-—
©
o
6 Press STOP on recording
unit, and then press STOP on playing
unit to end dubbing.
[DI
fiit HI
* When two Palmcorders are used for
dubbing, it is recommended that the
remote control VCR1 or VCR2 setting
should be used to avoid mis-operation.
* When two Palmcorders are connected
using the DV interface cable (not
supplied), a Video Editing Controller
cannot be used.
REC
Button
Button Unauthorized exchanging and/or copying of
copyrighted recordings may be copyright
infringement.
63