Playback Your Recordings Aaa Aa; Olapessabentnayhatavers - Panasonic Digital Palmcorder PalmSight PV-DV600 Operating Instructions Manual

Playback your Recordings
Playback using the LCD Monitor
You can also use the LCD monitor to Before you begin...
playback your recording. * Connect the Palmcorder to a power source
(pages 12, 13).
VOLUME KEY
» Insert a recorded cassette.
s Set Power to VCR.
1 Press LCD-OPEN to unlock the LCD
monitor and swing open.
Press REWIND/SEARCH to rewind
the tape.
7 = i d
)
oO
d a Press PLAY to start playback.
To adjust the volume:
Hold down VOLUME KEY until the volume
setting screen appears (page 27). Then
rotate VOLUME KEY to adjust the volume
of the built-in speaker. To disappear the
volume setting screen, hold down VOLUME
KEY again.
e Adjust the picture on the LCD monitor if
needed (page 31).
U
to
2.
O
O
G
(D
m.
t
=:
O
-
Built-in 4
Speaker Press STOP to stop playback.
* When the tape reaches its beginning
during rewind or rewind search, it will
stop automatically.
* If you press PLAY for more than 5
seconds, the Palmcorder will
start the Repeat Playback mode
when the tape reaches its end. The
letter "R >" will appear in the EVF
and LCD monitor.
To exit the Repeat
Playback mode,
turn the
You can place the Palmcorder on a table, Palmcorder OFF.
etc. for viewing. Rotate the LCD Monitor
180° and swing it up against the MO
Palmcorder body as shown. * When a tape recorded in LP mode on
another digital video camera is played
back on this unit, the picture may appear
mosaic.
* Using the LCD monitor reduces battery
operating time.
* Connect earphones (not supplied) to the
PHONES Jack.
35