Table of Contents
Advertisement
Playback using the LCD Monitor
You can also use the LCD monitor to
playback your recording.
LCD-OPEN
Button
REWIND
SEARCH
STOP
Button
Button
180°
90°
90°
You can place the Palmcorder on a table,
etc. for viewing. Rotate the LCD Monitor
180° and swing it up against the
Palmcorder body as shown.
200_400-K.30-39.p65
Playback your Recordings
VOLUME KEY
PLAY
Button
Built-in
Speaker
PHONE
Jack
35
Before you begin...
• Connect the Palmcorder to a power source
(pages 12, 13).
• Insert a recorded cassette.
• Set Power to VCR.
1
Press LCD-OPEN to unlock the LCD
monitor and swing open.
2
Press REWIND/SEARCH to rewind
the tape.
3
Press PLAY to start playback.
To adjust the volume:
Hold down VOLUME KEY until the volume
setting screen appears (page 27). Then
rotate VOLUME KEY to adjust the volume
of the built-in speaker. Hold down the
VOLUME KEY again to make the volume
setting screen disappear.
• Adjust the picture on the LCD monitor if
needed (page 31).
4
Press STOP to stop playback.
• When the tape reaches its beginning
during rewind or rewind search, it will
stop automatically.
• If you press PLAY for more than 5
seconds, the Palmcorder will
start the Repeat Playback mode
when the tape reaches its end. The
letter "R
" will appear in the EVF
and LCD monitor.
To exit the Repeat
Playback mode,
turn the
Palmcorder OFF.
Note
• When a tape recorded in LP mode on
another digital video camera is played
back on this unit, the picture may appear
mosaic.
• Using the LCD monitor reduces battery
operating time.
• Connect earphones (not supplied) to the
PHONE Jack.
00/06/14, 13:11
R
35
Hide quick links:
Advertisement
Table of Contents
