8. Attach any internal cables leading from the SBus card to the main logic board
(if applicable).
9. Attach any external cables that must be connected to the SBus card (if
applicable).
Figure 11–4
10. Refer to Chapter 7 to perform the following procedures:
4 Detaching the wrist strap
4 Closing the system unit
4 Reconnecting system components
11. Refer to Chapter 6 to turn the power on.
12. Refer to the guide for your SBus product to complete any required software
installation, configuration, or additional setup procedures.
SPARCclassic/SPARCclassic X/SPARCstation LX Service Manual ♦ Revision A, November 1993
112
Connecting the SBus Card