Sun Microsystems SPARCclassic Service Manual page 130

To replace the VSIMM on the main logic board:
1. Remove the faulty VSIMM.
See "Removing the VSIMM" on page 113. Make sure you use the wrist strap and
antistatic mat.
2. Install the new VSIMM.
The VSIMM is keyed so it can be installed only in one way. Grasp the VSIMM by
its top corners and align it with its connector (see Figure 11–7). Applying equal
pressure to both corners, push down the VSIMM until it is firmly seated in its
connector.
3. Refer to Chapter 7 to perform the following procedures:
4 Detaching the wrist strap
4 Closing the system unit
4 Reconnecting system components
4. Refer to Chapter 6 to turn the power on.
Figure 11–7
SPARCclassic/SPARCclassic X/SPARCstation LX Service Manual ♦ Revision A, November 1993
116
Installing the VSIMM