Sun Microsystems SPARCclassic Service Manual page 125

Place the SBus card on an antistatic surface (either an antistatic mat or the
antistatic bag in which the card was shipped).
4. If required, set the jumpers or switches on the card.
Refer to the manual supplied with the replacement SBus card.
5. Align the mounting plate of the new SBus card with the rectangular opening in
the system unit's back panel (see Figure 11–3 and Figure 11–4).
Position the card in the same location that the faulty card occupied. Insert the two
locating tabs on the card's mounting plate into the slots above the rectangular
opening in the back panel.
Figure 11–3 Positioning the SBus Card
6. Connect the SBus card to its slot.
Align the connector on the card with the SBus slot on the main logic board. Press
gently on the corners of the SBus card until the connection is secure (see Figure
11–4). Do not force the card.
Caution -
Do not press down on the SBus card retainer, as this can cause it to break.
Using excessive force to secure the connection may bend or damage the connector
pins.
7. Refer to the manual supplied with the replacement card for instructions on any
additional hardware setup.
Main Logic Board and Component Replacement
111