Pager Call - When The Unit Receives A Fax Or Voice Message - Panasonic KX-FP155 Operating Instructions Manual

Pager call - when the unit receives a fax or
voice message!
This feature allows your unit to call your pager when your unit receives a fax document or an
incoming voice message.
Press MENU
1
Display:
2 Press , then
3 Press or
If this feature is not required, select
"OFF".
4 Press SET
5 Enter your pager number up to 30 digits.
Example:
6 Press
SET
7 Enter your pager access code up to 10
digits if required.
Example:
Press
8 SET
The default code 07734 will show
"Hello!" on your pager.
If you want to change this message,
enter your message up to 30 digits.
Example:
.
SYSTEM SET UP
I H
PRESS NAVI.[
7 0 .
PAGER CALL
MODE=OFF
to select "ON".
PAGER CALL
MODE=ON
.
NO.=
NO.=12025551234
.
PIN=
PIN=12345678
.
MSG.=07734
MSG.=5555
Receiving Faxes
9 Press
The unit will dial the stored
number.
]
10 Check that your pager received
[±]
the pager test call.
11 Press
[±]
MENU
DIGITAL SP-PHONE
Note:
If you have subscribed to a Caller ID service,
your pager will display the caller's telephone
number before the number "11" or "22" (see
below) instead of the message.
When your pager receives a pager call
Your pager will beep and display as follows;
— "11" : when your unit receives a voice
message.
— "22" : when your unit receives a fax
document.
!
SET .
PAGER TEST
DIGITAL SP-PHONE
Display
SET
Pager
Example:
Your unit received
a fax document.
.
43