Battery Charging; Wall Mounting (Optional) - VTech CS6114 B Abridged User Manual

Battery charging

Once you have installed the battery, the screen indicates the battery status
(see the table below). For best performance, keep the handset in the
telephone base or charger when not in use. The battery is fully charged after
16 hours of continuous charging. Refer to the online Complete user's manual
for battery operating times.
Battery indicators
The screen is blank, or The battery has very
displays Place in charger little or no charge. The
and flashes. handset cannot be used.
The screen displays The battery has enough
Low battery and charge to be used for a
flashes. short time.
The screen displays The battery is charged.
HANDSET X.
If you place the handset in the telephone base or charger without plugging in
the battery, the screen displays No battery.

Wall mounting (optional)

Your telephone comes ready for tabletop use.
To mount your telephone on the wall:
1. Position the top hole at the back of the telephone base against the top
mounting stud [A].
2. Slide the telephone base down on the mounting
studs [A] and [B] until it locks into place.
Mounting
studs
Battery status
Charge without interruption
(at least 30 minutes).
Charge without interruption
(about 30 minutes).
To keep the battery charged,
place it in the telephone
base or charger when not
in use.
[A]
[B]
Telephone base
3
Action