Installation Of Battery In Handset - VTech sbc20-2432 Owner's Manual

Installation of Battery in Handset

The original Handset that is shipped with your 20-2432 system will be
automatically registered to the Base. This Handset is HANDSET 1.
As you register additional Handsets to the system, they will be assigned
extension numbers in the following order: HANDSET 2, HANDSET 3,
HANDSET 4, etc.
Whenever a charged Handset battery is installed, the Handset will
automatically begin SEARCHING FOR BASE (if previously registered), or
it will prompt you to ENTER BASE ID to register the new Handset. See
Registration and Operation for details.
Follow the steps below:
.
1 Remove the battery cover by
pressing on the indent and
sliding downward.
.
2 Place the new battery in the
Handset with the metal contacts
aligned
contacts
compartment.
.
3 Replace the battery cover by
sliding it upward.
.
4 If the new battery is not already
charged, place the handset in
the Base Unit, or a remote
charging stand, and allow it to
charge for 12 hours. After initial
charge, a maintenance charge
of 8 hours should be sufficient.
8
with the charge
in the battery