Register; Handset Deregistration - VTech sbc20-2432 Owner's Manual

Vtech sbc20-2432: user guide

Hide thumbs Also See for sbc20-2432:

Table of Contents

Register

Use this option to register a Handset to the 20-2432 Base. You can register

a total of eight Handsets to the 20-2432 Base. This process is activated

automatically whenever a new handset is powered up in range of the 20-2432

Base.

You will be prompted to enter the 15-digit Base ID code. See Registration and

Operation, located in the Getting Started section of the manual, for details.

Note: Base ID codes are 15 digits long and can include the following

characters: 0, 1, 2, 3, 4, 5, 6, 7, 8, 9, or * .

You can deregister all Handsets at one time. This causes the Base Unit

to forget that it has any Handsets at all. You may never have to perform this

procedure. One possible reason for deregistration is if you have the maximum

number of Handsets (8) registered to your Base, and one Handset should

require replacement, the Base will not register the new Handset, because

its eight memory slots are occupied. The deregistration procedure will clear

the Base Unit's memory, and you will be able to register each Handset again.

Individual Handsets cannot be deregistered.

CAUTION: Once you deregister, your Handsets will not be capable of making

or receiving calls. You will need to re-register each Handset, one at a time!!

To Deregister all Handsets:

At the Base Unit, in the idle (OFF) mode, press MENU.

Scroll down to SETUP BASE, then press OK.

Scroll down to DEREGISTER ALL, then press SET.

All system Handsets have been deregistered. To register your Handsets again,

see Registration and Operation, located in the Getting Started section of the

User's Manual, for details.

Table of Contents

20-2432