Table of Contents
Advertisement
Your 20-2432 Handset is equipped with a 2.5mm Headset Jack for use with
an optional accessory Headset for hands-free operation. If you choose to use
the Headset option, you must obtain an optional accessory Headset, which
is compatible with the 20-2432.
Once you have a compatible 2.5mm Headset, locate the Headset Jack on the
20-2432 Handset. Connect the plug on the Headset cord to the jack(under a
small rubber flag) on the cordless Handset. The plug should fit securely. Do
not force the connection.
Headset Operation connected to
the Handset
NOTE:
Whenever a compatible Headset is
connected to the cordless Handset, the
microphone on the Handset will be
muted. This is done to limit the effect
of background noise.
Headset Operation connected to
the Base Unit
The same type of Headset can be
connected to the Base Unit. Facing
the Base, the Headset jack can be
found on the near corner of the right
side panel.When using a Headset
attached to the Base, calls are made
and answered by pressing the
HEADSET key. This key is also used
to
end
your
Speakerphone and Base Headset
cannot be used simultaneously.
However, you can switch between the
two
modes
SPEAKERPHONE and HEADSET
without disconnecting your Headset.
Belt Clip
The 20-2432 is also equipped with
a detachable belt clip. Align the pins
on the inside edge of the clip with the
notches on the sides of the 20-2432
Handset. The belt clip should snap
securely into place. Do not force the
connection.
36
call.
The
Base
by
pressing
Advertisement
Table of Contents
