Installation Of Battery Pack In Handset - VTech VT5831 Manual

The original Handset that is shipped with your VT5831
system will be automatically registered to the Base. This
Handset is HANDSET 1.
As you register additional Handsets to the system, they will be assigned
extension numbers in the following order: HANDSET 2, HANDSET 3, and finally
HANDSET 4.
Whenever a Handset battery pack is installed, the Handset will automatically
begin SEARCHING FOR BASE (if previously registered), or it will prompt you
to ENTER BASE ID to register the new Handset.

Installation of Battery Pack in Handset

8
Follow the steps below:
1.
Remove the battery cover by
pressing on the indent and
sliding downward.
2.
Place the new battery pack in the
handset with the metal contacts
aligned with the charge contacts
in the battery compartment.
3.
Replace the battery cover by
sliding it upwards.
4.
If the new battery pack is not
already charged, place the
handset in the base unit, or a
remote charging stand, and allow
it to charge for 12 hours. After
initial charge, a maintenance
charge of 8 hours should be
sufficient.