Password Problems - HP NetServer LH 6000 Installation Manual

Chapter 12
12. Turn on power to the HP NetServer. The error message may be displayed:
0012-34 :
13. Press the [F2] function key and answer Yes to save the configuration, then
exit the Setup utility.

Password Problems

If you have forgotten the password, your HP NetServer will function normally,
but you will not be able to change the system configuration settings in the Setup
utility.
To reset the password, the procedure is the same for the rack-mount and the
pedestal HP NetServers once you gain access to the system board assembly.
1. Log off all users and gracefully shut down the network operating system
according to directions in your NOS documentation.
2. Power down the HP NetServer according to the instructions in Chapter 2,
"Controls, Ports, and Indicators."
3. Disconnect the power cords and cables and, if necessary, label each one to
support re-assembly.
CAUTION The power supplies will continue to provide standby current to
the NetServer until the power cable is disconnected.
4. For both rack-mounted and pedestal models, follow the instructions in
Chapter 3, "Opening and Closing the NetServer," to gain access to the
system board assembly.
NOTE
In the LH 6000r, this assembly is under the right cover; in the
LH 6000, it is under the top cover.
While you can reset the system password in the rack or in the pedestal, it is
recommended that you remove the system board assembly to perform
configuration changes.
5. Move switch 6 on the system board (labeled "Clear Password") to the ON
position (refer to Figure 12-1).
6. Plug in the power cords. Turn on power to the HP NetServer and allow it
to complete its startup routing. The old password will be erased.
7. Turn off power to the HP NetServer. Unplug the power cords.
All manuals and user guides at all-guides.com
Incorrect System Configuration
Troubleshooting
145