HP NetServer LH 6000 Installation Manual page 13

Chapter 1
CAUTION
The HP NetServers LH 6000r and LH 6000 each weigh up to
180 pounds (82 kgs). More than one person is required to lift a
server. Do not attempt to lift the NetServer by yourself.
Failure to observe this warning could result in serious injury,
or damage to the HP NetServer.
2. Familiarize yourself with the controls, ports and indicators.
Refer to Chapter 2, "Controls, Ports, and Indicators."
3. If you have optional internal items to add to the NetServer (memory,
accessory boards, mass storage, or processors), remove covers and the
bezel. If not, skip to step 8.
Refer to Chapter 3, "Opening and Closing the HP NetServer."
4. To install a processor and DIMMs, HP recommends that you remove the
system board assembly from the server chassis and install them at this
time.
Refer to Chapter 5, "Installing Additional Memory," and Chapter 7,
"Installing Additional Processors."
5. Install PCI hot-plug and non-hot-plug accessory boards in the HP
NetServer.
Refer to Chapter 6, "Installing Additional Boards."
6. Install internal non-hot-swap mass storage devices such as hard drives and
tape back-ups into the front of the HP NetServer.
7. Install the system board assembly into the NetServer if you removed it.
8. Install hot-swap mass storage devices into the front of the HP NetServer.
Refer to Chapter 4, "Installing Mass Storage Devices."
9. Reconnect all internal cables.
10. Replace covers and the bezel.
Refer to Chapter 3, "Opening and Closing the HP NetServer."
11. Install additional power supplies at the rear of the HP NetServer.
12. Connect the monitor, keyboard, and mouse.
Refer to Chapter 9, "Connecting the Monitor, Keyboard, and Mouse."
13. Connect external cables.
All manuals and user guides at all-guides.com
Setting Up the HP NetServer LH 6000/6000r
5