HP NetServer LH 6000 Installation Manual page 15

Chapter 1
NOTE Before proceeding with the next steps, determine the storage
management mode (HP NetRAID or LVD SCSI) to be used on
the NetServer.
l
HP NetRAID Controller Configuration Guide to plan the
RAID configuration.
l
change from the default RAID mode to the LVD SCSI mode.
6. Run Configuration Assistant and Installation Assistant: Select
"Configuration and Installation Assistant."
7. Configure Mass Storage. This HP NetServer ships with the hot-swap mass
storage device(s) NetRAID enabled. To configure the drive(s), either:
◊
Run HP NetRAID Assistant to configure one or more RAID logical
drives. To run HP NetRAID Assistant, select "Execute" from the
Configure Disk Array screen. For detailed information on HP
NetRAID, refer to the Integrated HP NetRAID Controller
Configuration Guide.
or
◊
Restart the HP NetServer.
a. Press function key [F2] when prompted on the boot screen to enter
the Setup Utility.
b. In the Configuration menu, select Embedded LAN and SCSI
Settings.
c. Use the space bar to change the SCSI setting from HP NetRAID to
LVD SCSI.
d. Press function key [F10] to save the configuration and exit the
utility program.
e. Answer "Yes" to the question "Save Configuration and Exit Now?"
The HP NetServer will reboot, and HP Navigator will restart.
8. Select the configuration mode from the next screen. Three configuration
modes are available. Refer to Chapter 10, "Configuring the HP NetServer."
9. Choose a NOS. Select the NOS and version to be installed.
10. Select the NOS installation mode: If you select certain versions of Novell
NetWare or Microsoft Windows NT Server, you will be asked, "Would
you like to use HP's automated mode of NOS installation?"
All manuals and user guides at all-guides.com
Setting Up the HP NetServer LH 6000/6000r
If HP NetRAID is the desired mode, refer to the Integrated
If LVD SCSI is the desired mode, run Setup Utility to
7