Technics SC-CH730 Operating Instructions Manual page 6

~—.
Right speaker
Connect the AC mains lead after you have connected ail other
cables.
Connect the flat cables.
Hold the connector with the recessed part up and press in at
the center until you hear a click.
1. Connect the shorter flat cable to the terminal of the A1 and
A2.
2, Connect the longer flat cable to the terminal of the B1 and
B2.
3. Connect the longest flat cable to the terminal of the C1 and
C2.
To disconnect the flat cable, hold the connector, and pull it out.
After connection, fold and press the cable as flat to the back of
the unit as possible. (To minimize noise pickup while listening
to an MW/LW broadcast)
Do not try connecting or disconnecting the flat
cables while the power is switched to ON.
Left speaker
Connect the FM indoor antenna.
The tip of the internal antenna wire should not come into
contact with any metal objects.
When you cannot get a good reception of FM radio broadcast:
@|nstall the antenna on a wall at a height and in a direction
which result in the best reception.
When you cannot get a good reception with this FM indoor
antenna, we recommend you install an FM outdoor antenna
(not included).
Connect the AM (MW/LW) loop antenna.
1. Attach the antenna holder to the rear panel of the tuner/
sound processor. Press the antenna holder hard enough to
get it fixed firmly in the piace, with a click.
2. Clamp the antenna with its cord come upward to the an-
tenna holder.
3. Connect the antenna terminal to the rear panel of the
tuner/sound pocessor.
While listening to an MW/LW broadcast, position the loop
antenna for the best reception.
You may attach the antenna
holder to a rack or other structure.
Use a screw (included) to attach
as shown in the figure.
%
To minimize noise pickup, bundle the loop antenna cord using a tape
or so to keep the flat cables away from the AM loop antenna cord.