Table of Contents
Advertisement
To use the sleep timer
(Available only from the remote control)
Select this timer when you want to use the timer to stop the music
automatically as you can fall asleep while listening. The system will
go into power standby mode after assigned time has passed (within
120 minutes, 30 min. intervals).
SLEEP
"SLEEP"
The following example in the figure shows how to set the system to
standby mode after 30 minutes.
While enjoying the desired source:
Press SLEEP.
"SLEEP" lights up.
Each time you press the button, the dis-
play will change as follows:
SLEEP 30-— SLEEP 60->SLEEP 90
t
1
SLEEP OFF<——_——SLEEP 120
SLEEP
To confirm the remaining of the sleep timer:
(While sleep timer is functioning:)
Press SLEEP.
The remaining time will be displayed.
To change the timer setting while sleep timer is
functioning:
1. Press SLEEP.
The remaining time will be displayed.
2. Press SLEEP to select the desired SLEEP timer.
Each time you press the button, the display will change as follows:
SLEEP 30-—SLEEP 60-» SLEEP 90
t
u
SLEEP OFF<_—____SLEEP 120
To use each timer mode in conjunction
To go to sleep listening to an FM broadcast and
wake up the next morning listening to a CD
1. Make a play timer setting fora CD.
2. Tune in the desired band and station, and adjust the volume level.
3. Make a sleep timer setting.
To make a timer recording from a radio
broadcast while sleeping, and wake up the next
morning listening to a tape
1. Make a record timer setting.
2. Make a play timer setting for deck 1, and switch the power to
standby mode. (Select "=~" of the reverse modes.)
Be sure to set the record timer to be off before the play timer will
begin.
To go to sleep listening to a CD, and then to
make a timer recording from a radio broadcast
1. Make a record timer setting.
2. Play a CD, and adjust the volume level.
3. Make a sleep timer setting.
Be sure to set the system into standby mode before the timer
recording will begin.
To go to sleep listening to a tape, and wake up
the next morning listening to a CD, and record
from a radio broadcast while going out
1. Make a record timer setting.
2. Make a play timer setting for a CD.
Be sure to set the timer play to be off before the timer recording
will start.
3. Playback the tape in deck 1, and adjust the volume level.
(Select "==>" of the reverse modes.)
4. Make a sleep timer setting.
Timer sequence priority:
Sleep timer, record timer, play timer is the timer operation of priority
in order. Be sure not to make each timer setting overlap.
For your reference:
@When the OFF time of the record timer and the ON time of the play
timer are the same. both timers will function.
When the OFF time of the play timer and the ON time of the record
timer are the same, both timers will function.
Advertisement
Table of Contents
