Program Play - Technics SC-CH730 Operating Instructions Manual

Program play
(Available only from the remote control)
This function allows you to program up to 24 tracks on a CD in any
order you choose.
This example in the figure shows how to program tracks 3, 5 and 7 in
sequence.
2 pe Press PROGRAM.
"PROGRAM' will light.
"PROGRAM"
1 2 3 Press the numeric button to
3 = = >1 Select the track you want to
COO © play in the desired sequence.
7 8 9 i)
OOO
Programmed track number
Programmed order
¥
Total playing time
Press >.
Play will start in the programmed se-
4
\_sal quence.
To cancel program play:
Press PROGRAM.
The CD player resumes sequential play mode.
To select a two-digit track:
Press 210.
For example:
Track no. 13: 2101-3
Track no. 20: 210-20
Track no. 35: 2103-5
To add an entry:
Press the numeric button corresponding to the track to be added.
When "FULL" appears:
The number of programmed tracks is limited to 24. No further tracks
can be programmed.
wae
8 .
2 bene pens bene
When "—-:——" appears:
The total playing time of the programmed tracks has exceeded
99 minutes 59 seconds, or you programmed track number 25 or
more. However, programming and play are still possible.
a HL.
yout
To clear a programmed track one by one:
(Using the numeric button)
1. Press CANCEL.
"CANCEL" lights.
2. Press the numeric button of the track you want to cancel.
3. Press CANCEL.
"CANCEL" goes out.
(Using <4 /<4<4 or >> />P1 on the CD player)
1. Press CANCEL on the remote control.
"CANCEL' lights.
2. Press Kt /<< or >> / PI repeatedly until the display shows
the track number you want to cancel.
3. (Within 10 seconds)
Press CANCEL.
4. Repeat steps 2 and 3 to finish cancelling track.
5. Press CANCEL.
"CANCEL" goes out.
To clear all tracks:
Press Mf once in the stop mode or twice in the play mode.