Table of Contents
Advertisement
Only compact discs having this mark can be
used with this unit.
COMPACT
DIGITAL AUDIO
H To remove a disc from its case
Press the center holder and lift the disc holding by the edges.
M@ To hold the disc
Hold the disc by the edges so the surface is not soiled with finger-
prints.
Fingerprints, dirt and scratches can cause skipping and distortion.
(Correct)
(Incorrect)
™@ To store a disc in its case
Insert the disc with label facing upwards and press downward at the
center.
@ If the surface is soiled
Wipe gently with a soft, damp (water only) cloth.
(Incorrect)
(Correct)
WM If the disc is brought from a cold to a warm
environment, moisture may form on the disc
Wipe this moisture off with a soft, dry, lint-free cloth before using the
disc.
Improper disc storage:
You can damage discs if you store them in the following places;
® Areas exposed to direct sunlight
Humid or dusty areas
¢ Areas directly exposed to a heat outlet or heating appliance
Handling precautions:
©Do not write on the label side with a ball-point pen or other writing
utensils.
©Do not soil with fingerprints.
H Selection of cassette tapes
You can use normal, high position, and metal tapes for playback
and recording:
The deck automatically identifies the kind of tape loaded, and sets
the bias (for recording), recording level, equalization accordingly.
Cassette tape exceeding 90 minutes:
These tapes are handy for their long playback and recording time but
be careful about repeatedly stopping, starting, rewinding and fast
forwarding these tapes in short intervals as they are thin, tend to
stretch and may become entangled in the mechanism.
Endless tapes:
Failure to operate these tapes correctly may cause the tape to wind
around the revolving parts.
For this unit, it is recommended to use the tpae which is appropriate
to the auto reverse mechanism.
@ If the tape loosens, take up the slack
Tape slack may cause the tape to break.
M@ To prevent erasure of recorded sounds
Remove the tabs with a screwdriver or a similar object.
Tab for side B
Tab for side A
To re-record on a protected cassette, cover the slot with adhesive
tape.
Adhesive tape
Detection hole
Do not cover the detection holes on high position and metal tapes.
@ Improper tape storage:
You can damage tapes if you store them in the following places;
ein high temperature (35°C or higher) or high humidity (80% or
higher) areas
ein a strong magnetic field (near a speaker, on top of a TV, etc.)
This can erase a recording.
® Areas exposed to direct sunlight
Advertisement
Table of Contents
