Table of Contents
Advertisement
18 Inspection and maintenance
The equipment is subject to pressure!
▶ Risk of severe injury or death
Depressurize the plant or plant component.
●
Completely drain the plant or plant component.
●
Hot plant components!
▶ Risk of burns
Only work on plant that has cooled
●
down.
Servicing and maintenance work must only be performed
●
by trained personnel.
Do not extend hand lever. GEMÜ shall assume no liability
●
whatsoever for damages caused by improper handling or
third-party actions.
In case of doubt, contact GEMÜ prior to commissioning.
●
The operator must carry out regular visual examination of the
GEMÜ products dependent on the operating conditions and
the potential danger in order to prevent leakage and damage.
The product also must be disassembled and checked for
wear in the corresponding intervals.
1. Have servicing and maintenance work performed by
trained personnel.
2. Wear appropriate protective gear as specified in plant op-
erator's guidelines.
3. Shut off plant or plant component.
4. Secure the plant or plant component against recommis-
sioning.
5. Depressurize the plant or plant component.
6. Actuate GEMÜ products which are always in the same po-
sition four times a year.
www.gemu-group.com
WARNING
CAUTION
CAUTION
18.1 Spare parts
18.1.1 Spare parts 0TL
Item
1
Body
2
Diaphragm
18, 19, 20
Mounting set (screws,
washers, nuts)
A
Actuator
35 / 42
18 Inspection and maintenance
19
18
Name
Order designation
K600
600...M
650 S30
9650...TL
GEMÜ 650TL
A
18
20
2
1
Advertisement
Table of Contents
