Panasonic CF-63 Series Operating Instructions Manual page 37

# Connecting Peripherals
Your peripheral does not
You need to use drivers conforming to Windows 95 Version 4 00 950B {OSR-2) Some
work (An error occurs while
earlier dnvers will no longer work
installing the driver)
For more information, please ask the source of the driver in question
Unable to print
• Check the computer-printer connection
• Make sure the printer is on
• Make sure the printer is in the online state
• Make sure paper is in the pnnter tray and there is no paper jam
• Has the Setup Utility been used to set [Parallel Port (Address)] to [Automatic (PnP)],
[378] or [3BC]'^
The cursor does not move
• Xhe Coffee break Password may be set, check if is displayed on the Status LCD If
from mouse operations
this is the case, input the Coffee break Password
• Check your mouse connections, then reboot the computer from the keyboard
From the keyboard, you may choose to press down on |^, then select [Shut Down]
The device connected to the
® Check the connection
serial port does not work
* Confirm that the device dnver for the serial port works Please refer to the reference
manual for the device
• Confirm that two mouse devices are not connected, one through the ext keyboard/mouse
port and the other through the serial port
• Try setting the [Internal Pointing Device] to [Disable] in the Setup Utility
• Has the Setup Utility been used to set [Senal Port] to [Automatic (PnP)] or [3F8]'^
External mouse or track
some circumstances, it a PS/2 external mouse with a serial interface conversion function
ball connected to the PS/2
connected to the port, it may not operate normally Connect it to the senal port
port does not work
A PC Card does not work
• card is properly inserted
• Confirm that the card conforms to the PC Card Standard
• A driver for Windows 95 may need to be installed
• Note that after a driver is installed, the computer must be rebooted
• There may be no interrupt request (IRQ) line available Deactivate unnecessary equip¬
ment using [Supervisor Setup] in the Setup Utility
• Read the PC Card's manual Or, you may need to call the source of the PC Card
You do not know the
C? 28
avaUable RAM module
The RAM module has not
Make sure the RAM module has been properly inserted
been recognized
The address map Cor IRQ,
Check the address map by going to [View Resources] m [Start] - [Settings] - [Control Panel]
I/O port address^ etc, is
' [System] - [Device Manager] - [Computer] - [Properties]
unclear
# Others
You wish to initialize the set-
See "Reinstalling Software" (G'page 39) for instructions on how to make the settings for
tings of each driver
each of the various required drivers
37