Mitsubishi MELIMP Series Instruction Manual page 143

Pr. 52 "main display screen data selection"
You can select the display data of the main display screen of the operation panel or FR-PU04
parameter unit (option).
Setting
Motor speed
Motor current
0
Output voltage
Alarm indication
Motor speed (during operation)
Preset speed (during stop)
100 Motor current
Output voltage
Alarm indication
5 Preset speed
6 Motor speed
8 Converter output voltage
9 Regenerative brake duty
Electronic overcurrent protection load
10
factor
11 Motor current peak value
12 Converter output voltage peak value
20 Cumulative energization time
23 Actual operation time
The actual operation time available by setting "23" is the cumulative value of motor
running time and does not include the motor stop time.
The actual operation time is incremented every hour. If the drive unit is powered off
before incrementing, the operation time of less than one hour during that period is
not stored.
The cumulative energization time and actual operation time available by setting
MEMO
"20" and "23" are up to 65535h. After that, the values return to 0 and incremented
again from 0. A value more than 9999h displayed on the operation panel is given as
"- - - -". You can use the FR-PU04 to confirm the value more than 9999h.
When the operation panel is used, the display unit is Hz, V or A only.
Refer to the FR-PU04 instruction manual when using the FR-PU04.
Display Data
8-56
Get other manuals https://www.bkmanuals.com
8 PARAMETER FUNCTIONS
Initial value
0
Unit Display Screen
r/min
A
V
These data can be displayed in

sequence by pressing the SET
key of the operation panel or the
r/min
SHIFT key of the parameter unit
(FR-PU04).
A
V

r/min
These data are displayed on the
r/min
voltage monitor screen.
V
After power-on, press the SET key
%
of the operation panel or the
% SHIFT key of the parameter unit
(FR-PU04) twice to display the
A
voltage monitor screen.
V
Refer to: Chapter 4, 4.3 Operation
h
Procedures
h