Sc Balance Adjustment; Color Burst Phase, Width Adjustment - Panasonic DVCPRO AJ-CA901P Service Manual

Electrical Adjustment for AJ-BS900HEN & CA900HEN

6-4. SC Balance Adjustment

BOARD BS DIGITAL
TP TP3
ADJ.
VR23 [SC-BAL1], VR24 [SC-BAL2]
INPUT AJ-BS900H Internal Color bar signal : ON
M. EQ Oscilloscope (with 75Ω termination)
SPEC. As shown below
1. Connect Oscilloscope to TP3 and then adjust
VR23 and VR24 so that the signal waveform
(envelope) becomes flat.
6-5. Color Burst Phase, Width
Adjustment
BOARD BS AUDIO
TP ENC1 OUT
ADJ. VR13 [BF PHASE], VR14 [BF WIDTH]
INPUT AJ-BS900H Internal Color bar signal : ON
M. EQ Oscilloscope (with 75Ω termination)
SPEC. A = 5.6µS +/-0.1µS
B = 2.25µS +/- 0.23µS
1. Set output signal mode on the AJ-BS900H to
Internal Color bar mode. (Press "BARS" button on
the AJ-BS900H.)
2. Connect Oscilloscope to ENC1 OUT and then
adjust VR13 so that the phase of color burst signal
A is within the specification.
3. Connect Oscilloscope to ENC1 OUT connector
and then adjust VR14 so that the Burst signal
width B is within the specification.
50%
50%
ELE-14
50%
A B