Placing Lens
Below shows lens type accompanying respective CA-2500 series. Lens hood is served as standard
corresponding to lens type.
CA-2500A
Standard, wide and telephoto lenses, and 2 macro rings
CA-2500S
Standard lens
CA-2500W
Wide lens
CA-2500T
Telephoto lens and 2 macro rings
CA-2500SW
Standard and wide lenses
CA-2500ST
Standard and telephoto lenses, and 2 macro rings
CA-2500WT
Wide and telephoto lenses, and 2 macro rings
Operation procedure
1.
Remove mount cover from lens
mount on body.
2.
Place lens on lens mount before
rotating clockwise.
l Be sure to insert lens straightly. If forcibly put
aslant, lens mount could be broken.
l Revolve lens until fixed.
For CA-2500A, CA-2500T, CA-2500ST, or CA-2500WT
In using a macro ring for either of CA-2500A,
CA-2500T, CA-2500ST, or CA-2500WT,
sandwich it between lens and lens mount.
3.
Align 2 pins of lens hood and 2 holes
of body. Then, insert lens hood as if
it covers lens. Finally, rotate screw
portion of lens hood clockwise.
l Select appropriate lens hood depending
on lens type. Inappropriate lens hood may
cause the lens head to be positioned back
from the lens hood, which leads to incorrect
measurement.
l Hold the circumference of lens hood.
l Rotate screw portion of lens hood until fixed.
Mount cover
Lens
Macro ring
Lens hood
Lens hood pin hole
16