Chapter 1: Service Procedures; General; Replacing A Controller; Replacing Component Box Components - Frymaster 1814E Series Service & Parts Manual

CHAPTER 1: SERVICE PROCEDURES

1.1 General

Before performing any maintenance on your Frymaster fryer, disconnect the fryer from the electrical
power supply.
When electrical wires are disconnected, it is recommended that they be marked in such a way as to
facilitate re-assembly.

1.2 Replacing a Controller

1. Disconnect the fryer from the electrical power supply.
2. The controller bezel is held in place by screws at the bottom. Remove the screws and slide the
bezel down.
3. Remove the two screws from the upper corners of the control panel. The control panel is hinged
at the bottom and swings open from the top.
4. Unplug the wiring harness from the connector on the back of the controller and disconnect the
grounding wire from terminal adjacent to the connector. Remove the control panel assembly by
lifting it from the hinged slots in the control panel frame ( If a fryer has a 3000 controller, mark
and remove all wires/harnesses prior to removing controller).
20-Pin Connector
5. Remove the controller from the control panel assembly and install the replacement controller.
Reinstall the control panel assembly by reversing steps 1-4 (If installing a 3000 controller, ensure
controller is configured and setup properly).

1.3 Replacing Component Box Components

1. Disconnect the fryer from the electrical power supply.
2. The controller bezel is held in place by screws at the bottom. Remove the screws and slide the
bezel down.
1814E SERIES ELECTRIC FRYERS
1-1
Ground Wire Terminal