Remote Control Diagram; Operating Instructions - CrimeStopper CS-2002DC SERIES III Installation And Operating Instructions Manual

5 BUTTON REMOTE TRANSMITTER:
BANK #1 (Directly Press Buttons)
Button 1: Arm
Button 2: Disarm
Button 3: Aux #1 (Trunk)
Button 4: Panic
Button 5: (Change to BANK #2)
BANK #2 (Press Button 5 FIRST,
then within 3 seconds Buttons 1-4)
Button 1: Silent Arm (No Chirp)
Button 2: Silent Disarm (No Chirp)
Button 3: Car Locator (5 successive Chirps)
Button 4: Aux #2
ACTIVE ARMING
To arm the alarm and lock the doors, press the #1 (Lock Symbol) button on the transmitter. You will hear a
single siren chirp and the lights will flash once. The system will arm, the doors will lock and the starter will be
disabled if these optional features are installed. The red LED in the vehicle will start flashing after 15 seconds.
After a short delay to allow vehicle and electronics to stabilize the system will be completely armed.
ALARM TRIGGERING
If there is an intrusion into the vehicle or hard impact to the body will sound the alarm and flash the lights for
45 seconds. After 45 seconds the system will automatically shut off and re-arm to continue to protect the
vehicle. If a door is left open, the unit will cycle a second time and still continue to protect the other un-
tampered zones.
DISARMING
Press the #2 (Unlock) button on the transmitter to disarm the alarm. You will hear 2 siren chirps and the lights
will flash twice. The LED stops flashing. Door will unlock and dome light will turn on if the options are
installed.

OPERATING INSTRUCTIONS

BUTTON 1
BUTTON 3
*GREEN LED Blinks once for Bank #1 and twice for Bank #2.
BUTTON 2
BUTTON 5
(ON SIDE)
PANIC
BUTTON 4