Remote Control Diagram; Operating Instructions - CrimeStopper Gargoyle CS-2001FC II Series Installation & Operating Instructions Manual

REMOTE CONTROL
4 BUTTON REMOTE TRANSMITTER:
#2
#1
DISARM
ARM
(UNLOCK)
(LOCK)
PANIC
#4
#3
TRUNK REMOTE
POP
PANIC

OPERATING INSTRUCTIONS

ACTIVE ARMING
To arm the alarm and lock the doors, press the #1 (Lock Symbol) button on the transmitter. You will hear a
single siren chirp and the lights will flash once. The system will arm, the doors will lock and the starter will be
disabled if these optional features are installed. The red LED in the vehicle will start flashing after 15 seconds.
After a short delay to allow vehicle and electronics to stabilize the system will be completely armed.
ALARM TRIGGERING
If there is an intrusion into the vehicle or hard impact to the body will sound the alarm and flash the lights for
45 seconds. After 45 seconds the system will automatically shut off and re-arm to continue to protect the
vehicle. If a door is left open, the unit will cycle a second time and still continue to protect the other un-
tampered zones.
DISARMING
To disarm the alarm and unlock the doors, press the #2 (Unlock Symbol) button on the transmitter. You will
hear 2 siren chirps and the lights will flash twice. The dome light turns on and the dash LED stops flashing.