Remote Control Diagram; Alarm Operation - CrimeStopper SecurLinc CS-2008PC Installation & Operating Instructions Manual

Advanced remote control alarm system
Table of Contents

Advertisement

5-Button One-Way Remote Functions:
BANK #1 (Directly Press Buttons)
Button 1: Arm / Lock
Button 2: Disarm / Unlock
Button 3: Aux #1 (Trunk Release)
Button 4: Panic
Button 5: (Change to BANK #2)
BANK #2 (Press Button 5 FIRST,
then within 3 seconds Buttons 1-4)
Button 1: Silent Arm (No Chirp)
Button 2: Silent Disarm (No Chirp)
Button 3: Aux #2
Button 4: Remote Start (With option expansion
BANK #3 (Press Button #5 two times
Then within 3 seconds Buttons 1-4)
Button 1: Arm / Lock (Car 2)
Button 2: Disarm / Unlock (Car 2)
Button 3: Aux #1 (Trunk Release Car 2)
Button 4: Remote Start (Car 2, with option expansion module)
ARMING:
Press the #1 button (Lock Symbol) on the remote to arm the system. The siren will chirp once and the lights
will flash once. The red LED in the vehicle will start flashing. The system will arm, (lock the doors, and the
starter will be disabled).
DISARMING:
Press Button #2 (Unlock Symbol) to disarm. The siren will chirp (2) times and the lights will flash (2) times.
The red LED in the vehicle will turn off. (Doors will unlock and the interior dome light will turn on if these
optional features are installed.)
TRIGGERING THE ALARM:
After a short 15 second Arming delay (to allow vehicle/electronics to settle), the system becomes fully
armed.
INTRUSION:
If there is an intrusion at the vehicle (door/hood/trunk opening) the alarm will sound for 45 seconds.
SHOCK/IMPACT:
A hard impact or shock to the vehicle body will trigger the shock sensor and trip the alarm for 20 sec.
ONE-TIME SILENT ARM/DISARM:
Press the Button #5 (Side button) first, then press Button #1 or #2 and the system will arm/disarm without a
chirps just on a one-time basis.
SILENT ARM & DISARM: (Programmable)
The system can programmed to ARM and DISARM silently without Siren Chirps. See programming Option #3.
ALARM PRE-WARNING:
If a low-level shock to the vehicle body is detected, the pre-warning sensor activates sounding 5 quick siren
chirps and 1 light flash.
5-BUTTON REMOTE OPERATION:
module: SLA-200)

ALARM OPERATION

BUTTON 1
BUTTON 3
*GREEN LED Blinks once for Bank 1, twice
for Bank 2, & 3 times for Bank 3
BUTTON 2
BUTTON 5
(ON SIDE)
PANIC
BUTTON 4

Advertisement

Table of Contents
loading

Table of Contents