Custom Override; Remote Control - CrimeStopper CS-2002DC Series II Installation And Operating Instructions Manual

CUSTOM OVERRIDE PROGRAMMING
Custom override allows the user to set a specific number of button presses (2-15) required to perform an emergency
override/disarm of the alarm system. This increases the level of security of the system, but you MUST MEMORIZE
how many button presses you have changed your system to use or the unit will not disarm in an emergency.
1. Enter programming mode. (See step #1 on page 9)
2. Press program button three times to go to option #3 "Passive Locks/Custom Override".
3. Press the Button #3 (TRUNK) on the remote transmitter.
4. Press and release the program again the number of times you desire in order to perform emergency disarm on this
alarm system. Press the program button 2-15 times only.
To test feature: Trip alarm system, turn key ON, press the program/valet button 2-15 times as programmed above
then continue to HOLD DOWN valet button on the LAST PRESS for 5 seconds. Alarm should disarm. If system does
not disarm, then disarm with the remote transmitter and try again. If system still does not disarm, then repeat steps
above.

REMOTE CONTROL

4 BUTTON CS-2002DC REMOTE TRANSMITTER:
#2
#1
DISARM
ARM
(UNLOCK)
(LOCK)
PANIC
#4
#3
TRUNK REMOTE
POP
PANIC
(SEE PAGE 17 FOR CS-2002DC SERIES II REMOTE CONTROL)