Table of Contents
Advertisement
Changing the unit's settings
Entering a password
You can limit play of DVDs unsuitable for some audiences. Play and
changes to the settings are not possible unless you enter a
password.
When setting ratings
The password screen is shown when you select levels 0 to 7.
1. Input a 4-digit password with the numbered buttons.
If you enter a wrong number, press [CANCEL] to erase it before
you press [ENTER].
Do not forget your password.
2. Press [ENTER].
3. Press [ENTER].
The password is entered and the unit is locked.
Now, when you insert a DVD-Video that exceeds the ratings
limit you set, a message appears on the television.
Follow the on-screen instructions.
When changing ratings
The password screen is shown when you select "Ratings".
1. Input your 4-digit password with the numbered buttons and press
[ENTER].
Unlock Recorder:
Change Password: To change your password
Change Level:
Temporary Unlock: To temporarily unlock the unit (the unit
2. Select the item with the joystick [ ,
Actual screens depend on the operation. Follow the on-screen
instructions.
86
RQT6035
To unlock the unit and return the rating to 8
To change the rating level
locks again if you switch it to standby or
open the disc tray)
] and press [ENTER].
!?
Digital output
Change these settings when you have connected equipment
through this unit's OPTICAL DIGITAL AUDIO OUT terminal.
PCM Down Conversion
Off (factory setting):
When you have used audio cables to connect the unit to other equip-
ment (analog connection
On:
When you have used an optical digital cable to connect the unit to
other equipment (digital connection
to 48 kHz/16 bit.
Output of audio with a sampling frequency of 96 kHz
Audio is output as follows in accordance with the connections and
settings you make.
Connection
Setting
Off
On
1
96 kHz audio is output if the DVD is unprotected, but the connect-
ed equipment must be able to handle such signals in order to play
them.
Dolby Digital
Bitstream (Factory preset):
When you have connected a unit with a built-in Dolby Digital
decoder.
PCM:
When you have connected a unit that doesn't have a built-in Dolby
Digital decoder.
DTS
Off (Factory preset):
When you have connected a unit that doesn't have a built-in DTS
decoder.
2
Bitstream:
When you have connected a unit with a built-in DTS decoder.
2
Set "Dolby Digital" to "PCM" and "DTS" to "Off" if the other equip-
ment doesn't have decoders. Incorrect settings can cause noise to
be output which can be harmful to your ears and speakers, and
audio will not be recorded properly to digital recording equipment.
page 78).
C
page 78). Output is limited
B
B
(digital)
No output
1
Output as 96 kHz
Converted and output
Converted and output
as 48 kHz/16 bit
as 48 kHz
2
C
(analog)
Advertisement
Table of Contents
