Table of Contents
Advertisement
Plug-in Auto Tuning
Note
Plug-in Auto Tuning does not work if you turn the unit on by press-
ing [û, OPEN/CLOSE] or [
, PLAY].
After the unit sets the clock automatically, it then adjusts the clock
everyday.
If the unit sets the time incorrectly, use "Time Zone Adjust" to cor-
rect it (
page 89).
You can give the stations captions (
If you connect the unit through a cable TV box or DSS receiver
(
page 76), tune to your local PBS station before starting auto
clock setting. Use manual clock setting (
work.
If there is no local PBS channel in your area then Auto Clock Setting
may not work correctly. In this case the time must be set manually
(
page 88).
Channel plan
The unit automatically determines the type of transmission (airwave
or cable) and puts them into channels as follows.
TV Mode
Band
VHF
UHF
CATV Mode
Band
VHF
CATV LOW BAND
CATV MID/SUPER BANDS
CATV HYPER BAND
ULTRA BAND
SPECIAL CATV CHANNEL
To start Plug-in Auto Tuning again (after moving
house, for example)
Main unit only
While the unit is on and stopped
1. Press and hold [ö, CH] and [õ, CH] for about five seconds.
The unit turns off.
2. Press [
/I, POWER] to turn the unit on.
The screen shown in step 1 on page 16 appears. Press [ENTER] to
start Plug-in Auto Tuning.
Antenna system, channel caption, and VCR Plus+ guide channel
settings all revert to the default values when you perform the above
procedure. Timer recording settings are also cleared.
page 92).
page 88) if this does not
Stations received by airwaves
2–13
14–69
Stations received by cable
2–13
95–99
14–36
37–65
66–94
100–125
1
17
RQT6035
Advertisement
Table of Contents
