Table of Contents
Advertisement
Play
Play fails to start even when
[√ , PLAY] is pressed.
Play starts but then stops
immediately.
"U11", "NO DISC", or "NO PLAY"
appears on the unit's display.
No response when buttons
pressed.
A title or chapter doesn't play
when it is selected.
Picture distorted during search.
There is ghosting.
Alternative soundtrack and
subtitles cannot be selected.
No subtitles.
Angle cannot be changed.
You have forgotten your ratings
password.
Displays
The display is dim.
"12:00" is flashing on the unit's
display.
"U11" appears on the unit's
display after using a lens cleaner.
Remote control
The remote control doesn't work.
Cannot operate the television.
Insert the disc correctly with the label facing up. '
This unit cannot play discs other than DVD-RAM, DVD-R, DVD-Video, Video CD, and CD. ^
The disc is dirty. Clean it.
The disc may be badly scratched.
You inserted a blank DVD-RAM or DVD-R.
Condensation has formed: Wait 1 to 2 hours for it to evaporate.
Some operations may be prohibited by the disc.
If the unit is not operating at all, press [
[
/I, POWER] again to turn the unit on. The unit may not be operating correctly due to lightning,
static electricity, or some other external factor.
Some titles and chapters on DVD-Video are not played when you have changed the ratings level.
,
Some distortion is normal.
Change the settings for "3D NR", "Block NR", and "Mosquito NR" to "0" or turn MPEG DNR off
with the on-screen menu icons. o
The languages are not recorded on the disc.
You may have to use the disc's menus to select languages. +
Subtitles are not recorded on the disc.
Turn the subtitles on. O
This function depends on software availability. Angles can only be changed during scenes where
different angles are recorded ("
Return the ratings setting to "8".
While the disc tray is open, press and hold [ î] and [ï ] on the main unit at the same time for
5 or more seconds.
Go to Display in the ACTION menus and change the display's brightness with "FL Display". M
The clock is not set.
Go to Set Up in the ACTION menus and set the clock with "Clock Settings". >
Take the cleaner out of the unit.
[DVD, TV] is not switched to "DVD".
Switch to "DVD" when operating this unit. *, 2
The remote control and main unit are using different codes.
Change the code on the remote control or main unit. N, n
The batteries are depleted. Replace them with new ones. 2
Point the remote control at the remote control sensor on the main unit. 2
Remove obstacles from between the remote control and main unit.
Change manufacturer code. Some televisions cannot be operated even if you change the code.
3
[DVD, TV] is not switched to "TV".
Switch to "TV" when operating the television. *
/I, POWER] to switch the unit to standby, then press
" appears on the display).
101
RQT6035
Advertisement
Table of Contents
