Setting The Channel Delay Time; Setting Id Scan/Search (Trunked Systems Only) - Uniden BC246T Owner's Manual

Notes:
• If you select 0, the scanner stays on the system for a
minimal time (only long enough to check current
system activity).
• The default setting is 2 seconds for each system.
• For conventional systems, all unlocked channels will
be scanned at least once regardless of this setting.
• The scanner moves to the next system after the hold
time expires, any current transmission ends, and the
channel delay time expires.

Setting the Channel Delay Time

program system
Menu
Select the system
Edit Sys Option
Set DELAY Time
This setting controls how many seconds the scanner
waits after a transmission ends before resuming
scanning. Enter a value from 1-5 or Off, then press E.
Notes:
• The default setting is 2 seconds for each system.
• This setting applies to all channels within the system.
Setting ID Scan/Search
(Trunked Systems Only)
program system
Menu
Select the system
Edit Sys Option
ID SCAN/SEARCH
This setting controls how the system will be scanned.
Select your setting, then press E.
ID Scan - the scanner only stops on channels you have
programmed into the system.
Programming/Editing Optional Settings
E
E
E
E
E
E
E
E
65