Setting System Frequencies; Entering/Editing Ltr Channel Groups - Uniden BC246T Owner's Manual

When the scanner prompts Confirm?, press E to accept
the settings. The scanner creates an empty LTR system,
with a default name of System nnN
nNn increments as you add new systems. L indicates that
this is an LTR system.
Next, refer to the appropriate section to set system-wide
options. For most settings, you can accept the default.
However, for the items in bold, you must enter informa-
tion in order for your scanner to scan the system.
• See "Editing the System Name" on Page 63
• See "Setting the System Hold Time" on Page 64
• See "Editing the System Quick Key" on Page 63
• See "Setting the Channel Delay Time" on Page 65
• See "Setting ID Scan/Search (Trunked Systems
Only)" on Page 65
• See "Reviewing Locked Out Frequencies" on
Page 89
• See "Setting Channel Attenuation (Conventional
Channels Only)" on Page 77
• See "Deleting Systems" on Page 71
• See "Copying Systems" on Page 71
• See "Setting System Frequencies" on Page 61
• See "Entering/Editing LTR Channel Groups" on
Page 61

Setting System Frequencies

SET FREQUENCIES
New FREQUENCY
Input a system frequency, then press E. The scanner then
prompts you to enter the LCN for the entered frequency.
Enter the LCN, then press E.
To enter additional frequencies, press
control to select New Frequency, then repeat the above.

Entering/Editing LTR Channel Groups

To enter channels in a system, first set up a channel
group (or groups) to hold the channels. Then, enter the
channel and channel parameters in the group(s).
E
E
Programming Radio Systems
61
L.
, use the scroll
Menu