Uniden BC246T Owner's Manual page 101

Scanner won't
stop scanning
a trunked
system.
Scanner won't
acquire the
data channel.
Missing replies
to
conversations.
If you still cannot get satisfactory results while using your
scanner or if you want additional information, please call
or write the Uniden Parts and Service Division.
The address and phone number are listed in the Warranty
at the end of this manual. If you would like immediate
assistance, please call Customer Service at
(800) 297-1023.
If you have Internet access, you can visit
http://www.uniden.com for additional information.
No ID's have been
programmed.
The ID's you have
stored are not
active.
The squelch might
need to be
adjusted.
The frequency
used for the data
channel might be
missing.
The scanner might
need to be
changed to a Type
1 scanner setup.
The fleet map
might be incorrect.
One or more of
the system's
frequencies might
not be entered.
The system you
are trying to scan
might be LTR or
EDACS.
101
Program one or more
ID's or use the ID
Search mode.
Wait for the ID's to
become active or
scan another system.
Adjust the squelch
threshold. See
"Turning On the
Scanner and Setting
the Squelch" on
Page 41.
Check your
frequency list for the
data channel.
Change to a Type 1
scanner setup. See
"Programming
Motorola Systems"
on Page 54.
Try another preset
fleet map or program
your own fleet map.
Make sure all the
system's frequencies
have been entered.
Set the scanner to
scan LTR or EDACS
systems. Review
"Programming LTR
Systems" on Page 60
and "Programming
EDACS Systems" on
Page 58.
Troubleshooting