Setting System Frequencies - Uniden UBC396T Owner's Manual

• See"Setting the Motorola Status Bit (Motorola Sys-
tems Only)" on Page 78
• See "Setting the End Code Operation (Motorola
Systems Only)" on Page 79
• See "Setting I-Call (Motorola and EDACS Sys-
tems Only)" on Page 79
• See "Setting Emergency Alert (Motorola and
EDACS Systems Only)" on Page 80
• See "Adjusting the P25 Level (Motorola and Con-
ventional Systems Only)" on Page 81
• See "Setting Control-Channel Only (Motorola Sys-
tems Only)" on Page 80
• See "Setting System Lockout" on Page 75
• See "Reviewing Locked Out Frequencies" on
Page 107
• See "Setting System Attenuation (Trunked Sys-
tems Only)" on Page 83
• See "Deleting Systems" on Page 83
• See "Copying Systems" on Page 83
• See "Setting System Frequencies" on Page 64
• See "Entering/Editing Motorola Channel Groups"
on Page 66

Setting System Frequencies

Program System
Menu
Select the system
Set Frequencies
Input a system frequency, then press the scroll control.
To enter additional frequencies, press
scroll control to select New Frequency, then repeat
the above.
Note: If you select Control Channel Only mode (see
"Setting Control-Channel Only (Motorola Systems
Only)" on Page 80), you only need to enter the
frequency(s) that can be assigned as the control
channel. Most frequency lists usually indicate which of
Programming Radio Systems
64
, use the
Menu