Default Settings; Setting Display Language - Siemens SITRANS FC720 Operating Instructions Manual

Default settings

Abbreviation
NV1, NV2
NCV
DRC
VSC
HT1
HT2
HT3
GVF
The following values are only available for the trend display to record data on the
microSD card. Additional information about data recording can be found in the
applicable Function Manual.
Only use the microSD card included with the SITRANS FC. Functionality of the
device cannot be guaranteed if other cards are used.
Tab. 39: Trend display
Abbreviation
MFL
DNS
TMP
VFL
PRS
CNC
NM1
NV1
PHS
FRQ
DRG
DRC
MBT
VSC
15.3 Default settings

15.3.1 Setting display language

1. Press [SET] switch for 2 seconds to enter [Operation level].
2. Press [▼] switch 1 time to enter [Operator].
3. Press [SET] switch to enter [Device setup].
4. Press [▼] switch until the menu [Lang] is selected.
5. Press [SET] switch to enter the [Lang] menu.
6. Press [▼] switch repeatedly until the desired language appears.
7. Press [SET] switch to select the desired language.
8. Press [SET] switch to confirm the language selected.
Measured quantity or identification
Net volume flow rate 1, 2
Corrected net volume flow rate
Drive current
Viscosity
24hours totalizer 1
24hours totalizer 2
24hours totalizer 3
Gas void fraction
Measured quantity or identification
Mass flow
Density
Temperature
Volume flow
Pressure
Concentration
Net mass flow rate 1
Net volume flow rate 1
Phase shift
Resonance frequency
Drive gain
Driving current
Transmitter temperature
Viscosity
ð Display switches to the next higher menu level.
System configuration and operation
A5E52748387-AA, 2023/09
FC7x0
133 / 180