Table of Contents
Advertisement
General Setup Information
Setting the RF UNIT
If you have connected a TV or color monitor equipped with audio/video input
jacks to your VCR, skip this adjustment.
Why this setting is necessary:
You must set the RF UNIT selector at the rear of the VCR properly so that your
TV can receive the correct signal from the VCR. Set the selector to 3 CH (Ch
3) or 4 CH (Ch 4), whichever channel is not active in your area.
1 Set the RF UNIT at the rear of the VCR to 3 CH or 4 CH, whichever is
not used in your area.
2 Press POWER.
The power lamp lights up on the front of the VCR.
A Cores ARES
;
a S
ames eo
3 Press TV/VTR.
The VTR indicator lights up in the display window.
4 Check that the TUNER indicator appears in the display window, then
select an active channel in your area by pressing CHANNEL +/~.
5 Turn on your TV and set it to the channel you selected in step 1.
Your TV is now tuned to the VCR. Whenever you use the VCR, set the TV
to this channel.
Note:
For details on adjusting TV channels, see your TV instruction manual.
Additional Information | 63
Advertisement
Table of Contents
