General Setup Information - Sony SLV-595SHF Operating Instructions Manual

General Setup Information
Setting the RF Unit
Why this setting is necessary:
You must set the RF UNIT selector at the rear of the VCR
property so that your TV can receive the correct signal from
the VCR. Set the selector to CH 3 (Ch 3) or
CH 4 (Ch 4), whichever is not active in your area.
If you connect a TV or color monitor equipped with A/V input
jacks, skip this adjustment.
1 Set the RF UNIT at the rear of the VCR to CH 3 or
CH 4, whichever is not active in your area.
2 Press POWER.
The power indicator lights up in the display window.
3 Press TV/VTR.
The VTR indicator lights up in the display window.
4 Check that the TUNER indicator appears in the
display window, then select an active channel in
your area by pressing CHANNEL +/-.
5 Turn on your TV and set it to the channel you
selected in step 1.
Your TV is now tuned to the VCR. Whenever you use the
VCR, set the TV to the preselected channel.
NOTE: |
For details on adjusting TV channels, see your TV ;
instruction manual.
60 | Additional Information