Table of Contents
Advertisement
The FINE TUNING indicator
The FINE TUNING indicator
shows the operable fine-tuning
range and stops at the optimal
point of reception. When the
VCR's tuner is receiving an
optimal broadcast signal, the
indicator stops at the center
position or one space right or
left of the center position.
However, even when a
broadcast is received in an
optimal condition, the indicator
may not be at the position
described.
26 | Preparation
Presetting Desired Channels or
Disabling Unwanted Channels
After automatic presetting is completed, you can disable and/or add channels
manually.
1 Follow steps 1 through 3 in "Presetting All Receivable
Channels Automatically" on page 25.
2 Press CHANNEL +/— on the VCR, or press channel
number buttons (0 through 9) on the Remote Commander
and ENTER to select the channel.
Once a channel was erased, it is skipped with CHANNEL
+/~. So, if you want to select the number that was erased,
use channel number buttons (0 through 9) and ENTER to
select the channel.
3 Press A or V to move the cursor to MANUAL SET.
4 To disable channels, press < or P to select ERASE.
To add channels, press < or P to select ADD.
5 Press EXECUTE.
When you press CHANNEL +/-, the disabled channels are removed and the added
channels are displayed.
Fine Tuning
Normally, the Auto Fine Tuning (AFT) setting on the TUNER PRESET menu is set
to ON, and the AFT function automatically fine-tunes the picture. If you change the
channel and the picture is not acceptable, fine-tune it manually.
a
Follow to steps 1 through 3 in "Presetting All Receivable Channels Automatically"
on page 25.
.
2 Press & or ¥ to move the cursor to FINE TUNING.
The fine tuning indicator is displayed.
3 Press < or P to get a clearer picture.
The AFT automatically switches to OFF.
4 If you cannot get a better picture, press & to move the
cursor to AFT and reselect ON. Then, press EXECUTE.
Advertisement
Table of Contents
