Advertisement
Do
▪ Center the target capture area in the middle of
the frame.
▪ Enroll and install within 100 ft. of panel.
Installation site conditions can reduce range
considerably.
▪ Make sure people will walk across the sensor
coverage area instead of directly toward the
sensor.
▪ Avoid backlit conditions (for example, facing a
window or other light source) because it may
result in poor image quality.
4. Choose applicable mounting bracket. The sensor hardware packet contains two mounting brackets for different
mounting scenarios. Use the provided large screws and anchors to attach the bracket to the wall. Leave at least 3
inches of clearance above the sensor to allow for battery replacement without uninstalling the mounting bracket.
5. Place and secure the Image Sensor on the arm and secure the arm on the mounting bracket in the desired
location. Adjust the horizontal positioning of the sensor to point towards the desired coverage area.
6. Secure the mounting arm location by sliding lock pin into the hole. Use the washer and remaining small screw to
secure the lock pin by screwing upwards through the bottom of the hole in the mounting bracket.
https://answers.alarm.com/Partner/Installation_and_Troubleshooting/Image_Sensor/Image_Sensor_Version_3/Interlogix_Sim...
Don't
▪ Set sensor on a flat surface.
▪ Set sensor across from mirrors or reflective
surfaces.
▪ Face sensor toward or close to areas that have
metallic objects or electronics (to avoid
interference with RF communication).
▪ Install in an area where there are obstructions
in front of or around the camera lens (for
example, walls and ceilings within 90 degrees
and 2 ft. around the camera). This type of
installation will result in washed out night
captures.
▪ Install outdoors. Sensor is for indoor use only.
Updated: Fri, 10 Mar 2023 20:24:24 GMT
8
Advertisement
