Table of Contents
Advertisement
24. SERVICE PROCEDURE
24.2 INITIAL 50 HOURS SERVICE
24.2.1
REPLACING DRIVE TRAIN PRESSURE FILTER
REMARK
If the pressure filter indicator light on the instrument panel, remains on at
operating oil temperature with the engine running, the pressure filter must
be changed.
1. With the engine stopped, operate the transmission/steering
lever several
times to relieve any pressure. Open the battery box side door. Remove all
outside dirt from filter. Using a filter wrench remove the spin on filter. Wipe
the filter base, removing all of the old oil from the seal area.
2. Coat the seal (1) on the new filter (2) with clean oil. Install the filter by
threading (do not spin) it onto the filter base (3) until the seal contacts the
base, turn the filter by hand an additional % to % turn.
REMARK
Do not over-tighten
the filter or use any tools for installation
because this
can damage the gasket and filter.
REMARK
Mechanical over-tightening
may distort the filter header threads or damage
the element seal.
3. Check the level in the drive train system.
3-26
Advertisement
Table of Contents
